NEC SL2100 - Page 17

Issue 1.0
SL2100 DT920 (ITK-8LCX) User Guide 5
No. Name Function
(1)
Handset Used to send/receive voice.
(2)
Back Key To return to previous window.
(3)
Speaker To Originate a call with handsfree.
(4)
Dial Keypad To dial the called party number or feature access code.
(5)
Hold key To place a call on hold.
(6)
Transfer key
Allows the terminal user to transfer established calls to another
terminal, without attendant assistance.
(7)
Speaker Key (with light)
To control the built-in speaker which can be used for handsfree
dialing or monitoring.
(8)
Cursor Key
To enter a selected item after navigating the menu. This key is
also used to display the shortcut menu for frequently-used
features.
(Note: Only for classic mode)
Volume (UP/DOWN) key
To adjust speaker/receiver volume, and ringer volume while off-
hook. To display the directory (DIR) by pressing the down key
while on-hook.
Right key (Directory)
To access Last Number Redial.
(Note: Only for classic mode)
Left key (Redial)
To display the Call History.
(Note: Only for Classic Mode)
(9)
Menu Key
To access the menu of terminal. Only “Phone” and “Settings” icons
function. Directory and History are not supported from this page
and are accessed from the Cursor button.
(10)
Mic Key
MIC LED on Microphone is On, LED off Microphone is muted. LED
must be on for handsfree response. MIC key also works for
handset.
(11)
Feature Key (with light)
To activate features such as terminal setup and to program One-
Touch Speed Calling keys.
(12)
Answer Key (with light) To answer the incoming call, when LED on this key is lit.
(13)
Recall Key
To finish a call and hear the dial tone to make an another call
(same as Flash Key).
(14)
Programmable Keys
(with light)
These keys can be programmed as Flexible line key/
Programmable feature key by system administrator.
(15)
Home Key
To display the Utility menu or check the status of programmable
keys press and hold this button.
To check the status of a programmable key, press this button
(16)
Soft keys
The feature name is shown at the bottom of the LCD. The
appropriate feature key is displayed on the screen according to the
call handling process.