1.
MWSET (Message Waiting - Set)
Allows a station to set a Message Waiting indication or
lamp.
HOLD (Call Hold)
Permits a station user to hold a call in progress and to
return to the previously held call.
MWOFF (Message Waiting - Cancel)
Allows a station to cancel a Message Waiting indication
or lamp.
FDB (Call Forwarding – Busy Line)
Permits a call to a busy station to be immediately forwarded
to a predesigned station.
FDA (Call Forwarding – All Calls)
Permits all calls designated for a particular station to be
routed to another station regardless of the busy or idle
status of the called station.
FDL (Logged Out IP Station – Call Destination)
Enables a system to transfer the call to appropriate
station when Dterm whose LOGGED OUT IP STATION
Ŕ CALL DESTINATION has already been registered is
in logout status.
S-SPD (Speed Calling - System)
Allows a station user to call certain frequently dialed
numbers using fewer digits (abbreviated call codes)
than would normally be required.
CAS (CAS-Switch Hook Flash)
Allows the user to send a switchhook flash while on an
outside trunk.
UCDBO (UCD Busy Out)
Allows a station user to block UCD calls and to cancel
Busy Out.
FLASH (Flash)
Provides the station with a switchhook flash.
FDN (Call Forward - No Answer)
Permits a call to an unanswered station to be forwarded
to a predesignated station if the called station does not
answer within a predetermined period of time.
C-RPT (ISDN Malicious Call Trace)
Allows the user to initiate a Call Trace on ISDN calls
only.
G-SPD (Speed Calling - Group)
Allows a station user to share a set of common Speed
Calling numbers with other station users in the group.
P-RLS (Privacy Release)
Allows another station to depress a busy line button
and enter the conversation of a station already
engaged in communication.
DND (Do Not Disturb)
Allows a station user to deny access to the station line
for incoming calls.
E-OVR (Executive Override)
Enables selected stations users, upon encountering a
busy condition at an internal station, to bridge into the
busy connection.
PAGE (Button Page)
Allows the user to toggle between pages when two
numbers are registered on One-Touch Speed Calling
key.
CW (Call Waiting)
Enables a busy station to receive a second incoming call.
To Next Page
Loading...
