EasyManua.ls Logo

NEC UNIVERGE DT310 - Installing Directory Card; Attaching Handset

NEC UNIVERGE DT310
91 pages
To Next Page IconTo Next Page
To Next Page IconTo Next Page
To Previous Page IconTo Previous Page
To Previous Page IconTo Previous Page
Loading...
23
INSTALLING DIRECTORY CARD
A directory card (also known as an abbreviated dialing
table) can be attached to the telephone sets. The
directory card can be used to record often dialed
numbers or other important information. Directory
cards are available as options.
STEP 1: Remove the protective sheet from the cover.
STEP 2: Attach the cover to the directory card and
then attach it to the directory card holder.
ATTACHING HANDSET
STEP 1: Insert the coiled cord plug into HANDSET
connector on the back of the telephone until
you hear it click.
STEP 2: Thread the coiled cord through the groove as
shown in the figure below.
Note:
To remove the directory card, pinch the two sides
of the directory card holder inward until the tabs
release and pull the holder out of the grooves.
DT330/310
Cover
Directory Card
Holde
r
Grooves
DT330/310
Telephone
Coiled Cord
Groove
HANDSET
Connector
Modular Plu
g

Table of Contents

Other manuals for NEC UNIVERGE DT310

Related product manuals