NEC Univerge SV9100 - Page 201

Issue 4.0
SV9100 Programming Manual 2-161
16
Forced Release of Held Call
Enable/Disable forced release for
calls on Hold. If enabled, the
system disconnects a call if it is
on Hold longer than a
programmed interval (Program
24-01-05). If disabled, forced
disconnection does not occur.
Program 24-01-01 also affects
this option.
0 = Disable (No)
1 = Enable (Yes)
0 24-01-01
24-01-05
17
Trunk to Trunk Warning Tone
for Long Conversation Alarm
Enable/Disable the Warning
Tone for Long Conversation
feature for DISA callers.
0 = Disable (No)
1 = Enable (Yes)
0
18
Warning Beep Tone Signaling
0 = Disable (No)
1 = Enable (Yes)
0
19
Privacy Mode Toggle Option
Enable/Disable a trunk ability to
be switched from private to non-
private mode by pressing the line
key or Privacy Release function
key.
0 = Disable (No)
1 = Enable (Yes)
0
20
Block Outgoing Caller ID
Allow (1)/Prevent (0) the system
from automatically blocking
outgoing Caller ID information
when a user places a call. If
allowed (i.e. block, enabled), the
system automatically inserts the
Caller ID block code (defined in
14-01-21) before the user dialed
digits.
0 = Disable (No)
1 = Enable (Yes)
0 14-01-21
21
Caller ID Block Code
Enter the code, up to 8 digits, that
should be used as the Caller ID
Block Code. This code is
automatically inserted before
dialed digits if Program 14-01-20
is set to 1.
Dial (up to eight digits)
67 14-01-20
22
Caller ID to Voice Mail
Enable/ Disable the system ability
to send the Caller ID digits
(Remote Log-On Protocol) to
voice mail.
0 = Disable (No)
1 = Enable (Yes)
0
23
--- Not Used ---
Item
No.
Item Input Data Default
Related
Program