NEC Univerge SV9100 - Page 243

Issue 4.0
SV9100 Programming Manual 2-203
43
Video Mode
0 = Disable
1 = Enable
0 This Program is used to
select the video function
with the standard SIP
terminal. If the standard
SIP terminal supports the
video function, the
SV9100 transfers the
video CODEC in SDP
information.
44
Using
Standard SIP
Display for
CPN
0 = Disable
1 = Enable
0 This Program is used to
Enable or Disable the
system to send INVITE
Fromtag Display attribute
which is sent from a
standard SIP terminal as
CPN to ISDN and if there
is no Display attribute
from standard SIP
terminal, the system will
not refer to either PRG
21-12-01 or 21-13-01 and
no CPN will be sent.
45
NAT Plug &
Play
0 = Disable
1 = Enable
0 Select sending RTP port
number to remote router.
(0) uses result from
negotiation result, (1)
from received RTP
packet. Effective only
when 10-46-14 is to NAT
Mode.
10-46-14
46
Door Phone
Number
(Read Only)
0 = Not assigned
1 ~ 8 = Door Phone No.
0
Indicates automatically
assigned IP Door Phone
Number after system
registers the Door Phone
port. System assignes the
number not to duplicate with
the Door Phone connected
to 2PGDAD. (Read Only)
10-03
(DLCA)
PGD
47
Registration
Expire Timer
for NAT
0 = Disable
60 ~ 65535(sec)
180
On a per station basis, this
setting defines the SIP
registration expiry timer. If
this value is set to 0, for a
NAPT terminal, the value in
PRG 84-23- 01 is applied.
Note: Version 9000 or higher
is required.
10-46-14
Item
No.
Item Input Data Default Description
Related
Program