NEC Univerge SV9100 - Page 247

Issue 4.0
SV9100 Programming Manual 2-207
Default
Programmable keys 1~8 are Trunk Line keys (key 1 = Trunk Line 1, key 2 = Trunk Line 2, etc.). All other
programmable keys are undefined.
Function Number List
[1] Normal Function Code (00 ~ 99) (Service Code 751)
Line Key Function Number Additional Data
LK01 01 (Trunk Line Key) 1
:: :
LK08
01 (Trunk Line Key) 8
LK09 0 (No Setting) 0
:: :
LK48 0 (No Setting) 0
Function Number List
[1] Normal Function Code (00 ~ 99) (Service Code 751)
Function
Number
Function Additional Data LED Indication
00 Not Defined
01 DSS/One-Touch Extension number or any
numbers (up to 24 digits)
Red On: Extension Busy
Off: Extension Idle
Rapid Blink (Red): DND or Call
Forward
02 Microphone Key (ON/OFF)
Red On: Mic Off
Off: Mic On
03 DND Key
Red On: DND
04 BGM (ON/OFF)
Red On: BGM On
Off: BGM Off
05 Headset
Red On: Headset in use
06 Transfer Key None
07 Conference Key
Red On: Conference call setup occurring
08 Incoming Call Log
Rapid Blink (Red): New call log
Red On: Call log
Off: No call log
09 Day/Night Mode Switch Mode number (1~8)
Red On: Mode active
10 Call Forward – Immediate
Red On: Forwarded
11 Call Forward – Busy
Red On: Forwarded