NEC Univerge SV9100 - Page 30

Issue 4.0
1-2 Introduction
1. Enter the programming mode.
2. 15-07-01
tells you to enter the programming mode, dial 150701 from the telephone dial
pad. After you do, you will see the message “15-07-01 TEL” on the first line of
the telephone display. This indicates the program number (15-07), item number
(01), and that the options are being set for the extension. The second row of the
display “KY01 =
01” indicates that Key 01 is being programmed with the entry
of
01. The third row allows you to move the cursor to the left or right,
depending on which arrow is pressed. To learn how to enter the programming
mode, refer to Section 3 How to Enter Programming Mode below.
SECTION 3 HOW TO ENTER PROGRAMMING MODE
To enter programming mode:
1. Go to any working display telephone.
In a newly installed system, use extension (port 1).
2. Do not lift the handset.
3. Press Speaker.
4.
#  #  .
5. Dial the system password + Transfer.
Refer to the following table for the default system passwords. To change the
passwords, use 90-02 : Programming Password Setup.
15-07-01 TEL
KY01 = *01

Password