NEC Univerge SV9100 - Call Routing Mailbox Options

Issue 4.0
SV9100 Programming Manual 2-593
Description
Use 47-08 : Call Routing Mailbox Options to set the options for mailboxes assigned as Call Routing
Mailboxes in 47-07-02: Routing Mailbox Type.
Program 47 : InMail
47-08 : Call Routing Mailbox Options
Level:
IN
Input Data
Routing Mailbox Number 1~32
Item
No.
Item Input Data Default
01
Dial Action Table
Assign the Dial Action Table to the Call Routing
Mailbox. The Dial Action Table defines the dialing
options for the call Routing Mailbox.
1~32
(Dial Action Table 1~32)
1 (Dial Action Table 1)
02
Screened Transfer Timeout
(Scrn Trf Timeout)
Set the time a Screened Transfer (TRF) from the
Automated Attendant rings an unanswered extension
before recalling.
This option has a similar function as Customize:
Mailbox Options: Call Routing: [Call Handling] Options:
Delay Rings Before Redirect Transfer in SV8100
InMail.
0~255 (sec)
Entering 0 causes
immediate recall.
15
03
Time Limit for Dialing Commands
(Dialing Timeout)
Determine the time SV8100 InMail waits for an
Automated Attendant caller to dial before routing the
call to the Timeout destination.
Be sure your Dial Action Tables have a Timeout action
programmed.
If the caller waits too long to dial:
When the associated Dial Action Table has a Timeout
action programmed, the caller routes to that
destination.
When the associated Dial Action Table does not have
a Timeout action programmed, the Instruction Menu
repeats three times and then SV8100 InMail hangs up.
0~99 (sec)
Entering 0 causes the
Automated Attendant to
immediately route callers
to the Timeout destination
programmed in the active
Dial Action Table.
5