NEC Univerge SV9100 - Page 1076

1076
Program
Number
Program Name/Description
Input Data
Default
15-05-50
IP Telephone Terminal Basic Data Setup –
Peer to Peer Mode
On a per station basis enable or disable Peer to
Peer mode.
If enabled, MUC mode resource settings are
used in Programs 84-27-22 and 84-27-23.
If disabled, non-MCU mode resource settings
are used in Programs 84-27-20 and 84-27-21.
0 = Disable
1 = Enable
1
20-13-46
Class of Service Options (Supplementary
Service) – Remote Conference
Set Class of Service option for Remote
conference.
0 = Disable
1 = Enable
COS 1 ~ 15 = 1
20-34-01
Remote Conference Group Setting –
Remote Conference - Name
Set name for remote conference.
Maximum of 12 characters.
Conferences
1 ~ 4 =
Conf 1 - Conf 4
Conferences
5 ~ 20 = blank
20-34-02
Remote Conference Group Setting –
Remote Conference - Password
Set password for remote conference.
Maximum of 4 numbers.
Conferences
1 ~ 4 = 1111
Conferences
5 ~ 20 = blank
20-34-06
Remote Conference Group Setting –
Remote Conference - Password Mode
Set whether users are prompted to enter a
password to access the conference. Normal will
prompt users to enter a password. If set to Skip
no password is required to enter a conference.
0 = Normal
1 = Skip
0
20-34-07
Remote Conference Group Setting – MCU
Mode for Remote Conference
Set the MCU video mode for remote
conference.
Setting this value for mode 1 or 2 determines
whether 84-27-22 or 84-27-23 is used.
0 = Disable
1 = Mode 1
2 = Mode 2
0
84-10-01
ToS Setup – ToS Mode
When Input Data is set to 1, Item No. 07 is
invalid. When Data is set to 2, Items
No. 02 ~ 06 are invalid.
0 = Disable (Invalid)
1 = IP Precedence
2 = Diffserv
0
84-10-02
ToS Setup – Priority, IP Precedence
1 = Router queuing priority.
0 ~ 7
0 = Low
7 = High
0
84-10-03
ToS Setup – Low Delay
1 = Optimize for low delay routing.
0 ~ 1
0 = Normal Delay, Low Delay
0
84-10-04
ToS Setup – Wideband (Throughout)
1 = Optimize for high bandwidth routing.
0 ~ 1
0 = Normal Throughput
1 = High Throughput
0