NEC Univerge SV9100 - Page 1109

1109
Program
Number
Program Name/Description
Input Data
Default
11-12-10
Service Code Setup (for Service Access) –
Station Speed Dialing
Assign Service code used for accessing
System Speed Dial bins (default #2).
MLT, SLT
0 ~ 9,
*
, # Maximum of eight
digits
813
11-12-11
Service Code Setup (for Service Access) –
Group Speed Dialing
Customize the service code used for group
speed dialing.
MLT, SLT
0 ~ 9,
*
, # Maximum of eight
digits
814
13-01-01
Speed Dialing Option Setup – Speed Dialing
Auto Outgoing Call Mode
Designate trunk or intercom outgoing mode.
0 = Trunk Outgoing Mode
1 = Intercom Outgoing Mode
0
13-01-03
Speed Dialing Option Setup – Number of
Common Speed Dialing Bins
Designate the bins the system uses for System
Speed Dialing.
0 ~ 10000
0 = No Common Speed Dialing
1000
13-02-01
Group Speed Dialing Bins
Designate the starting and ending bin numbers
the system uses for Group Speed Dialing.
01 ~ 64
0 ~ 9999
Starting bin number range:
0 ~ 9990
Ending bin number range:
0 ~ 9999
No Setting
13-03-01
Speed Dialing Group Assignment for
Extensions
For Group Speed Dialing, assign extensions to
Speed Dialing groups.
01 ~ 64
1
13-04-01
Speed Dialing Number and Name – Speed
Dialing Data
Enter the System and Group Speed Dialing
numbers and names.
Maximum of 24 digits.
1 ~ 9, 0, *, #
Pause (Press line key 1)
Recall/Flash (Press line key 2)
@ = Code to wait for answer
supervision in ISDN (Press line
key 3)
No Setting
13-04-02
Speed Dialing Number and Name – Name
Assign a name to each System Speed Dial bin.
Maximum of 12 characters
(Use dial pad to enter name)
No Setting
13-04-03
Speed Dialing Number and Name – Transfer
Mode
When the incoming caller ID matches the
number programmed in the speed dial bin, this
setting determines the destination of the call.
0 = Not Used
1 = Internal Dial
2 = Incoming Ring Group (IRG)
0
13-04-04
Speed Dialing Number and Name – Transfer
Destination Number
When the incoming caller ID matches the
number programmed in the speed dial bin, this
setting determines the destination of the call.
If Transfer mode is (Refer to
Program 13-04-03):
1 = Internal Dial Mode
1 ~ 9, 0, *, #, P, R, @
(Maximum 24 Characters)
2 = Incoming Ring Group
0 ~ 100 (IRG Number)
P = Pause R = Recall
@ = Additional Digits when
using ISDN functionality
No Setting