1205
Speed Dialing Number and Name – Transfer
Destination Number
Store transfer destination number data in the
Speed Dialing areas.
Maximum of 24 characters
If Transfer mode is (Refer to
13-04-03):
1 = Internal Dial Mode
1 ~ 9, 0, *, #, P, R, @
2 = Incoming Ring Group
0 ~ 100 (IRG Number)
P = Pause R = Recall
@ = Additional Digits when
using ISDN functionality
Speed Dialing Number and Name –
Incoming Ring Pattern
Store incoming ring pattern data in the Speed
Dialing areas.
Incoming Ring Pattern
0 = Normal Pattern
1 ~ 4 = Tone Pattern (1 ~ 4)
5 ~ 9 = Scale Pattern (1 ~ 5)
10 ~ 13 = Tone Pattern (5 ~ 8)
Basic Trunk Data Setup – Transmit Gain
Level for Conference and Transfer Calls
Select the Transmit CODEC gain level used by
the trunk when it is part of an Unsupervised
Conference.
1 ~ 57 (-15.5dB ~ +12.5dB in
0.5dB intervals)
Basic Trunk Data Setup – Receive Gain
Level for Conference and Transfer Calls
Select the Receive CODEC gain level used by
the trunk when it is part of an Unsupervised
Conference.
1 ~ 57 (-15.5dB ~ +12.5dB in
0.5dB intervals)
Basic Trunk Data Setup – Trunk-to-Trunk
Transfer
For each trunk, enter 1 to enable loop
supervision.
Class of Service for Extensions
Assign a Class of Service (1 ~ 15) to an
extension.
Day Night/Mode: 1 ~ 8
Class of Service of Extensions
(1 ~ 15)
Extension port
101 = Class 15
All other
extension port =
Class 1
Class of Service Options (Administrator
Level) – Set/Cancel Automatic
Trunk-to-Trunk Transfer
Turn Off or On an extension user ability to use
the Trunk-to-Trunk Forwarding service codes.
Class of Service Options (Administrator
Level) – Forced Trunk Disconnect (analog
trunk only)
Turn Off or On an extension user ability to use
Forced Trunk Disconnect. This allows the
extension user to disconnect an Unsupervised
Conference in progress.
0 = Off
1 = On
COS 1~14 = 0
COS 15 = 1
To Next Page
Loading...
