NEC Univerge SV9100 - Page 1253

1253
Program
Number
Program Name/Description
Input Data
Default
11-07-01
Department Group Pilot Numbers – Dial
Assign a Department Group pilot number for
the Voice Mail (maximum of eight digits). The
extensions are assigned to the group in
Program 16-02-01.
Maximum of eight digits.
No Setting
14-01-22
Basic Trunk Data Setup – Caller ID to Voice
Mail
Enable/Disable the system ability to send the
Caller ID digits to voice mail.
Trunks 1 ~ 400
0 = Disable
1 = Enable
0
14-02-10
Analog Trunk Data Setup – Caller ID
Enable/Disable a trunk user ability to receive
Caller ID information.
Trunks 1 ~ 400
0 = No
1 = Yes
0
15-02-08
Multiline Telephone Basic Data Setup –
Automatic Handsfree
Set whether pressing a key accesses a
One-Touch Key or preselects the key.
0 = Preselect
1 = One-Touch (Automatic
Handsfree)
1
15-02-26
Multiline Telephone Basic Data Setup – MSG
Key Operation Mode
Determine whether an extension MSG key
should function as a Message key or Voice Mail
key. If set as a Message key, users can press
the key to call the voice mail only when they
have new messages.
0 = Message Key
1 = Voice Mail Key
0
15-02-28
Multiline Telephone Basic Data Setup –
Message Waiting Lamp Color
Determine whether an extension Message
Waiting Lamp lights Green or Red when a
message is received.
0 = Green
1 = Red
1
15-02-37
Multiline Telephone Basic Data Setup –
Voice Mail Message Wait Lamp Color
Set up various message wait lamp cycle
options for lamp color.
0 = Green
1 = Red
1
15-02-38
Multiline Telephone Basic Data Setup –
Voice Mail Message Wait Lamp Cycle
Select the cycle method that the Large LED
flashes when the extension has a VM Message
Waiting set to the extension.
1 = Cycle 1
2 = Cycle 2
3 = Cycle 3
4 = Cycle 4
5 = Cycle 5
6 = Cycle 6
7 = Cycle 7
3
15-03-01
Single Line Telephone Basic Data Setup –
SLT Signaling Type
For each UNIVERGE SV9100 voice mail
extension, set this option to 1.
0 = DP
1 = DTMF
1
15-03-03
Single Line Telephone Basic Data Setup –
Terminal Type
Enter 1 for this option to allow a single line port
to receive DTMF tones after the initial call
setup. Enter 0 to have the port ignore DTMF
tones after the initial call setup. For Voice Mail,
always enter 1 (e.g., receive DTMF tones).
0 = Normal
1 = Special
0