NEC Univerge SV9100 - Page 1393

1393
Program
Number
Program Name/Description
Input Data
Default
84-19-40
SIP Extension IP CODEC Information Basic
Setup – G.726 Jitter Buffer (min)
Define the minimum setting for the G.726 Jitter
Buffer.
0 ~ 160ms
30
84-19-41
SIP Extension IP CODEC Information Basic
Setup – G.726 Jitter Buffer (Average)
Define the average setting for the G.726 Jitter
Buffer.
0 ~ 160ms
60
84-19-42
SIP Extension IP CODEC Information Basic
Setup – G.726 Jitter Buffer (Max)
Define the maximum setting for the G.726 Jitter
Buffer.
0 ~ 160ms
120
SIP Extension Basic Information Setup:
Program
Number
Program Name/Description
Input Data
Default
84-20-01
SIP Extension Basic Information Setup –
Registrar/Proxy Port
Define SIP station Proxy Port.
1 ~ 65535
5070
84-20-02
SIP Extension Basic Information Setup –
Session Timer Value
Define the periodic refresh time that allows both
user agents and proxies to determine if the SIP
session is still active.
0 ~ 65535 seconds
180
84-20-03
SIP Extension Basic Information Setup –
Minimum Session Timer Value
Define the minimum allowed value for the SIP
session timer.
0 ~ 65535 seconds
180
84-20-04
SIP Extension Basic Information Setup –
Called Party Info
Define the SIP Extension presented Caller ID
information.
0 = Request URI
1 = To Header
0
84-20-05
SIP Extension Basic Information Setup –
Expire Value of Invite
Define the time out response value for SIP
invite.
0 ~ 256 seconds
180
84-26-01
IPL Basic Setup – IP Address
Assign the IP address for each DSP on the
GPZ-IPLE.
xxx.xxx.xxx.xxx
Slot 1 =
172.16.0.20
84-26-02
IPL Basic Setup – RTP Port Number
Assign the RTP port number to be used for
each DSP on the GPZ-IPLE.
Only even numbered ports are supported.
0 ~ 65534
VoIP GW1 =
10020