NEC Univerge SV9100 - Page 1394

1394
Program
Number
Program Name/Description
Input Data
Default
84-26-03
IPL Basic Setup – RTCP Port Number (RTP
Port Number + 1)
Assign the RTCP port number to be used for
each DSP on the GPZ-IPLE.
0 ~ 65534
VoIP GW1 =
10021
IP Phone Configuration:
Program
Number
Program Name/Description
Input Data
Default
15-01-01
Basic Extension Data Setup – Extension
Name
Define the extension/virtual extension name.
Maximum of 12 characters.
STA 101 = Ext
101
STA 102 = Ext
102, etc.
15-05-02
IP Telephone Terminal Basic Data Setup – IP
Phone Fixed Port Assignment
MAC Address of registered MLT SIP phone is
stored and/or can input the MAC address of an
MLT SIP phone so when it comes online it is
provided with the extension which the MAC
address matches.
MAC address
00-00-00-00-00-00 to
FF-FF-FF-FF-FF-FF
00-00-00-00-00-
00
15-05-07
IP Telephone Terminal Basic Data Setup –
Using IP Address
Review the registered IP Phones IP Address
[Informational Only].
0.0.0.0 ~ 255.255.255.255
0.0.0.0
15-05-15
IP Telephone Terminal Basic Data Setup –
CODEC Type
Assign the registered IP Phone Codec type of
the MLT SIP – Reference Program 84-11 Dterm
IP Codec Basic Information.
1- Type 1
2- Type 2
3- Type 3
4- Type 4
5- Type 5
1
15-05-16
Authentication Password
Assign the authentication password for SIP
single line telephones.
Maximum of 24 characters.
No Setting
15-05-18
IP Telephone Terminal Basic Data Setup – IP
Duplication Allowed Group
For an adapter that has one IP address coming
into it but multiple extensions off of it. Enable
this option for all extensions in the group so the
CPU knows that the one IP Address is assigned
to multiple extensions.
0 = Disable
1 = Enable
0
15-05-40
IP Telephone Terminal Basic Data Setup –
Calling Name Display Info via Trunk for
Standard SIP
Sets the incoming calling name display type on
a standard SIP terminal. Trunk name is the first
priority and abbreviated (SPD) name is second
priority.
0 = Both name and number
1 = Name only
2 = Number only
3 = None
0