NEC Univerge SV9100 - Page 1397

1397
Program
Number
Program Name/Description
Input Data
Default
24-09-02
Call Forward Split Settings – CO Call
Forwarding Destination for Both Ring, All
Call, No Answer
Assign CO Call Forwarding Destination for ring,
all call and no answer.
Maximum of 24 digits (0 ~ 9,
*
,
#, @, P, R)
@ = Wait for Answer
Supervision - ISDN trunks only
P = Pause - Analog Trunk Only
R = Hook flash - Analog Trunk
Only
No Setting
24-09-03
Call Forward Split Settings – Interim Call
Forwarding Destination for Both Ring, All
Call, No Answer
Assign Intercom Call Forwarding Destination
for ring, all call and no answer.
Maximum of 24 digits (0 ~ 9,
*
,
#, @, P, R)
@ = Wait for Answer
Supervision - ISDN trunks only
P = Pause - Analog Trunk Only
R = Hook flash - Analog Trunk
Only
No Setting
24-09-04
Call Forward Split Settings – CO Call
Forwarding Busy Destination
Assign CO Call Forwarding for busy
destinations.
Maximum of 24 digits (0 ~ 9,
*
,
#, @, P, R)
@ = Wait for Answer
Supervision - ISDN trunks only
P = Pause - Analog Trunk Only
R = Hook flash - Analog Trunk
Only
No Setting
24-09-05
Call Forward Split Settings – Intercom Call
Forwarding Busy Destination
Assign Intercom Call Forwarding for busy
destinations.
Maximum of 24 digits (0 ~ 9,
*
,
#, @, P, R)
@ = Wait for Answer
Supervision - ISDN trunks only
P = Pause - Analog Trunk Only
R = Hook flash - Analog Trunk
Only
No Setting
80-01-01
(16)
Service Tone Setup – Lockout Tone
Lock Out Tone Repeat Count.
Value 0 ~ 255
Out of Range Call Warning Notification:
Program
Number
Program Name/Description
Input Data
Default
24-02-15
System Options for Transfer – SIP Out of
Range Timer
When not receiving any response within this
timer setting, system determines SIP terminal is
out of range. When set to 0, timer is invalid.
0 ~ 30 seconds
4