NEC Univerge SV9100 - Page 197

197
Related Features
Alphanumeric Display
Automatic Route Selection (ARS)
Call Appearance (CAP) Keys
Code Restriction
Dial Tone Detection
Handsfree Answerback/Forced Intercom Ringing
Long Conversation Cutoff
Microphone Cutoff
Programmable Function Keys
Trunk Groups
Trunk Group Routing
Guide to Feature Programming
Program
Number
Program Name/Description
Input Data
Default
10-03-XX
ETU Setup
Use program 10-03-XX to setup and confirm
the basic configuration data for each blade.
This program represents different data
depending on the blade installed in the slot.
The assigned data varies
depending on the blade installed
in the slot.
11-01-01
System Numbering
Set system numbering plan.
11-09-01
Trunk Access Code
If required, change the single-digit Trunk
Access Code (normally 9). If you change this
code, you must also review the settings in
Program 11-01-01 for the new code selected.
Dial (maximum of four digits)
9
11-09-02
Trunk Access Code – 2nd Trunk Route
Access Code
Assign the Service Code set up in Program
11-01-01 for Alternate Trunk Route Access.
Dial (maximum of four digits)
No Setting
11-10-27
Service Code Setup (for System
Administrator) – Trunk Port Disable for
Outgoing Calls
Define the service code which should be used
by an extension user to block a trunk from
being used for outgoing calls.
MLT, SLT
0 ~ 9,
*
, # Maximum of eight
digits
745