295
Class of Service Options (Outgoing Call
Service) – Block Outgoing Caller ID
Turn Off or On a user Class of Service from
automatically blocking outgoing Caller ID
information when a call is placed. If block is
enabled, the system automatically inserts the
Caller ID block code *67 (defined in Program
14-01-21) before the user dialed digits (this
requires Program 14-02-10 to be enabled). If
block is disabled, the system outdials the call
just as it was dialed by the user.
Class of Service Options (Outgoing Call
Service) – Display E911 Dialed Extension
Name and Number
Turn Off or On an extension ability to display
the name and number of the extension that
dialed 911.
Class of Service Options (Outgoing Call
Service) – ARS Override of Trunk Access
Map
Turn Off or On an extension user ability to
override the trunk access map programming for
outgoing calls.
Class of Service Options (Outgoing Call
Service) – Voice Over to busy Virtual
Extension
Enable/Disable an extension ability to voice
over to a busy virtual extension.
Class of Service Options (Incoming Call
Service) – Second Call for DID/DISA/DIL/
E&M Override
Turns Off or On the extension ability to receive
a second call from a DID, DISA, DIL, or tie line
caller.
With this option set to 1, the destination
extension must be busy for a second DNIS caller to
ring through. If the destination extension does not
have a trunk or CAP key available for the second
call and a previous call is ringing the extension but
has not yet been answered, the second caller hears
busy regardless of this program setting.
Class of Service Options (Incoming Call
Service) – Caller ID Display
Turn Off or On the Caller ID display at an
extension.
Class of Service Options (Incoming Call
Service) – Sub Address Identification
Define whether an extension displays the Caller
Sub-Address.
To Next Page
Loading...
