NEC Univerge SV9100 - Page 364

364
Default Settings
Disabled
Related Features
 Central Office Calls, Answering
 Direct Inward Line (DIL)
 Direct Inward System Access (DISA)
 Off-Hook Signaling
 Paging, External
Programmable Function Keys
Station Message Detail Recording
Transfer
Guide to Feature Programming
Program
Number
Program Name/Description
Input Data
Default
10-03-01
ETU Setup
Set up and confirm the basic configuration data
for each blade. This program represents
different data depending on the blade installed
in the slot.
The assigned data varies
depending on the blade installed
in the slot.
10-09-01
DTMF and Dial Tone Circuit Setup
If the system has DTMF DID trunks, be sure to
reserve at least one circuit for analog trunk
DTMF reception (type 0 or 2). There must be
an available receiver for each DTMF DID trunk.
Use the following as a guide when allocating
DTMF receivers:
In light traffic sites, allocate one DTMF receiver
for every 10 devices that use them.
In heavy traffic sites, allocate one DTMF
receiver for every five devices that use them.
0 = Common Use
1 = Extension Only
2 = Trunk Only
Circuit/Resource
01 ~ 08 = 1
(Extensions)
Circuit/Resource
09 ~ 32 = 2
(Trunks)
Circuit/Resource
33 ~ 144 = 0
(Common)
When
GPZ-BS10 is
installed, 81 ~
144 are available
14-05-01
Trunk Group – Trunk group Number
Put DID trunks in the same trunk group (other
than group 1). If you have different types of
DID trunks, put each type in a separate trunk
group.
Trunk Port 1 ~ 400 =
Priority 1 ~ 400
Default = Trunks
1 ~ 400 assigned
to trunk group 1
with priorities
equal to the
trunk number.
Trunk 1 = Priority
1 Trunk 400 =
Priority 400.