NEC Univerge SV9100 - Page 369

369
Program
Number
Program Name/Description
Input Data
Default
25-01-03
VRS/DISA Line Basic Data Setup – VRS/
DISA Transfer Alarm
Determine whether the system should use
option 0 or option 1 for calls.
0 = Normal
1 = Alarm
0
25-02-01
DID/DISA VRS Message
For each trunk port and each night mode, select
the message source (0 = No Message,
1 = VRS, 2 = ACI, 3 =S LT), assign the VRS
message number to be used as the Automated
Attendant Message for each trunk, which is
assigned as VRS/DISA [with VRS = 01 ~ 48
(VRS message number), with ACI = 1 ~ 4 or
01 ~ 16 (ACI group number), with SLT = 1 ~ 8
or 01 ~ 64 (Department Group number)].
0 = No Message
1 = VRS (01 ~ 100 VRS
Message Number)
2 = ACI (01 ~ 04 ACI Group
Number)
3 = Department Groups (01 ~ 64
Extension Group Number)
0
25-03-01
VRS/DISA Transfer Ring Group With
Incorrect Dialing
For each trunk port, set what happens to a call
when the DISA or Automated Attendant caller
dials incorrectly or waits too long to dial. The
call can either disconnect (0) or Transfer to an
alternate destination (a ring group, In-Skin/
External, Centralized). When setting the DISA
and DID Operating Mode, you make an entry
for each Night Service mode.
Ring Groups:
1 ~ 100
Trunk Ports:
001 ~ 400
Day/Night Mode:
1 ~ 8
0 = Disconnect
1 ~ 100 = Incoming Ring Group
101 DSPDB-VM
102 = In-Skin/External Voice
Mail or InMail
103 = Centralized VM
104 = Speed Dial Bin (table
Program 25-15-01)
0
25-04-01
VRS/DISA Transfer Ring Group With No
Answer/Busy
For each trunk port (001 ~ 400), set the
operating mode of each DISA trunk. This sets
what happens to the call when the DISA or
Automated Attendant caller calls a busy or
unanswered extension. The call can either
disconnect (0) or Transfer to an alternate
destination (a ring group, In-Skin/External,
Centralized). When setting the DISA and DID
Operating Mode, you make an entry for each
Night Service mode.
Ring Groups:
1 ~ 100
Trunk Ports:
001 ~ 400
Day/Night Mode:
1 ~ 8
0 (Disconnect)
1 ~ 100 (Incoming Ring Group)
102 (In-Skin/External Voice Mail
or InMail)
104 (Speed Dial table Program
25-15-01)
0
25-05-01
VRS/DISA Error Message Assignment
For each trunk that is answered by the VRS,
enter the VRS message (1 ~ 48) the outside
caller hears if they dial incorrectly after answer.
If you enter 0, the call reroutes according to
Program 25-03 and Program 25-04. Make one
entry for each Night Service mode.
0 ~ 100 (0 = No Setting)
0