NEC Univerge SV9100 - Page 430

430
Terminals
Multiline Terminal (DT400/DT300)
Required Component(s)
GCD-8DLCA/ GCD-16DLCA or GPZ-8DLCB or GCD-LTA
Related Features
Night Service
Guide to Feature Programming
Program
Number
Program Name/Description
Input Data
Default
11-10-51
Service Code Setup (for System
Administrator) – Power Saving for Power
Save Group
Use to determine the Service Code setting for
the Power Save feature (On/ Off) in the Power
Saving Group.
MLT, SLT
0 ~ 9,
*
, # Maximum of eight
digits
731 (NA)
12-02-01
Automatic Night Service Patterns – Start
Time
Defines the daily pattern of the automatic mode
switching. Each mode group has 10 patterns.
These patterns are used in Programs 12-03
and 12-04. The daily pattern consists of 20
timer settings.
This option defines the start time.
0000 ~ 2359
12-02-02
Automatic Night Service Patterns – End
Time
Defines the daily pattern of the automatic mode
switching. Each mode group has 10 patterns.
These patterns are used in Programs 12-03
and 12-04. The daily pattern consists of 20
timer settings.
This option defines the end time.
0000 ~ 2359
12-02-03
Automatic Night Service Patterns –
Operation Mode
Defines the daily pattern of the automatic mode
switching. Each mode group has 10 patterns.
These patterns are used in Programs 12-03
and 12-04. The daily pattern consists of 20
timer settings.
This option defines the operation mode the
system should be in during each time number.
1 ~ 8
1 or 2 depending
on the time
pattern and time
number.