NEC Univerge SV9100 - Page 573

573
Guide to Feature Programming
Program
Number
Program Name/Description
Input Data
Default
20-18-01
Service Tone Timers – Extension Dial Tone
Time
After completion of dial tone time Intercom dial
tone, a telephone user has this time to dial the
first digit of the Intercom call.
0 ~ 64800 seconds
30
20-18-02
Service Tone Timers – Busy Tone Timer
After Program 20-18-01 expires Busy Tone will
play for time programmed in this memory block.
0 ~ 64800 seconds
15
80-01-01
Service Tone Setup – Repeat Count
Customize the system basic tones and system
service tones. The system must be reset for
the changes to take affect.
0 ~ 255 (0 = until On-Hook)
Refer to Table 2-
31 Service Tone
Setup Defaults,
Program
80-01-01
80-01-02
Service Tone Setup – Basic Tone Number
The following features require that the system
tones listed below be changed to match the
table. After changing these settings the
system must be reset for the changes to take
effect.
Call Screening
Call Holding
Busy Greeting
Await Answer Transfer
1 ~ 33
0 = No Tone
33 = Default Time Slot
Operation
None