NEC Univerge SV9100 - Page 583

583
Program
Number
Program Name/Description
Input Data
Default
15-02-26
Multiline Telephone Basic Data Setup – MSG
Key Operation Mode
Determine whether an extension MSG key
should function as a Message key or Voice Mail
key. If set as a Message key, the user can press
it to call the voice mail only when they have new
messages. If set as a Voice Mail key, it
functions as a normal Voice Mail key (it is not
active if Centralized Voice Mail is used).
0 = Message Key
1 = Voice Mail Key
0
15-02-28
Multiline Telephone Basic Data setup –
Message Waiting Lamp Color
Determine whether an extension Message
Waiting Lamp lights Green or Red when a
message is received.
0 = Green
1 = Red
1
15-02-37
Multiline Telephone Basic Data Setup –
Voice Mail Message Wait Lamp Color
Select the color of the large LED when a voice
mail message is waiting at the extension.
0 = Green
1 = Red
1
15-03-01
Single Line Telephone Basic Data Setup –
SLT Signaling Type
For each UNIVERGE SV9100 voice mail
extension, set this option to 0.
0 = DP
1 = DTMF
1
15-03-03
Single Line Telephone Basic Data Setup –
Terminal Type
Enter 1 for this option to allow a single line port
to receive DTMF tones after the initial call
setup. Enter 0 to have the port ignore DTMF
tones after the initial call setup. For Voice Mail,
always enter 1 (e.g., receive DTMF tones).
0 = Normal
1 = Special
0
15-03-09
Single Line Telephone Basic Data Setup –
Caller ID Function – for External Module
This option must be 0 when voice mail is used
or the integration code for the disconnect
function is incorrect.
0 = Disable (Off)
1 = Enable (On)
0