NEC Univerge SV9100 - Page 69

69
Program
Number
Program Name/Description
Input Data
Default
14-07-01
Trunk Access Map Setup
Set up the Trunk Access Maps. This sets the
access options for trunks.
0 = No access
1 = Outgoing access only
2 = Incoming access only
3 = Access only when trunk on
Hold
4 = Outgoing access and access
when trunk on Hold
5 = Incoming access and access
when trunk on Hold
6 = Incoming and Outgoing
access
7 = Incoming access, outgoing
access and access when trunk
on Hold
Trunk Access Maps: 1 ~ 400
Access Maps
1 ~ 400 = Trunk
Ports 1 ~ 400
assigned with
option 7 access
(incoming and
outgoing access
and access
when trunk is on
Hold).
15-06-01
Trunk Access Map for Extensions
Assign Trunk Access Maps to extensions.
Trunk Access Maps: 1 ~ 400
1
20-03-04
System Options for Single Line Telephones
– Dial Sending Start Time for SLT or ARS
When ARS or an analog extension user
accesses a trunk and dials an outside call, the
system waits this time before outdialing the first
digit.
0 ~ 64800 seconds
3
20-06-01
Class of Service for Extensions
Assign a Class of Service (1 ~ 15) to an
extension.
Day Night/Mode: 1 ~ 8
Class of Service of Extensions
(1 ~ 15)
Extension port
101 = Class 15
All other
extension port =
Class 1
20-08-17
Class of Service Options (Outgoing Call
Service) – ARS Override of Trunk Access
Map
Turn Off or On an extension user ability to
override the trunk access map programming
(Program 14-07-01 and Program 15-06-01) for
outgoing calls.
0 = Off
1 = On
COS 1 ~ 15 = 0
21-02-01
Trunk Group Routing for Extensions
Assign Program 14-06 routes to extensions.
Day/Night Mode: 1 ~ 8
Route Table Number:
0 ~ 100
(0 = No Setting)
1
26-01-01
Automatic Route Selection Service – ARS
Service
Enable/Disable ARS.
0 = Disabled (ARS service is
Off)
1 = Enabled (ARS service is On)
0