699
DT800/DT700 Server Information Setup –
NAT Mode
Turns On/Off the DT700 NAT mode of the
system.
Network Address – Network Address
This program sets the IP or Network address
for phones that are not to be routed through the
NAPT translations.
For example, if a system had multiple NAPT
phones and another site, with multiple IP
phones connected via a VPN connection, you
would not want the phones connected over the
VPN to use the NAPT feature. The network
address (or single IP phone addresses) of the
Remote location would be entered here. This is
for the IP Phones at this location to not use the
NAPT feature.
0.0.0.0 ~ 126.255.255.254
128.0.0.1 ~ 191.254.255.254
192.0.0.1 ~ 223.255.255.254
Network Address – Subnet Mask
This program sets the netmask for the IP
Addresses assigned in Program 10-58-01.
128.0.0.0 | 192.0.0.0 | 224.0.0.0
|240.0.0.0 | 248.0.0.0 | 252.0.0.0
|254.0.0.0 | 255.0.0.0
|255.128.0.0 | 255.192.0.0
|255.224.0.0 | 255.240.0.0
|255.248.0.0 | 255.252.0.0
|255.254.0.0 | 255.255.0.0
|255.255.128.0 | 255.255.192.0
|255.255.224.0 | 255.255.240.0
|255.255.248.0 | 255.255.252.0
|255.255.254.0 | 255.255.255.0
|255.255.255.128
|255.255.255.192
|255.255.255.224
|255.255.255.240
|255.255.255.248
|255.255.255.252
|255.255.255.254
|255.255.255.255
IP Telephone Terminal Basic Data Setup –
NAT Plug and Play
This program is valid when Program 10-46-14
is On (NAT feature activated).
Select sending RTP port number to remote
Router, use from negotiation result (0) or
received RTP packet (1).
SV9100 uses this program to decide a
destination port of RTP transmitting packets
from IPLE to a remote IP terminal. If “0:OFF” is
selected, the destination port of RTP
transmitting packets will be a SIP/SDP
negotiation result.(same behavior as before). If
you chose “1:ON”, the destination port of RTP
transmitting packet will be the same port of a
source port of a receiving RTP packet on IPLE.
To Next Page
Loading...
