NEC Univerge SV9100 - Page 714

714
Guide to Feature Programming
Program
Number
Program Name/Description
Input Data
Default
10-12-01
GCD-CP10 Network Setup – IP Address
Assign the IP Address.
0.0.0.0 ~ 126.255.255.254
128.0.0.1 ~ 191.254.255.254
192.0.0.1 ~ 223.255.255.254
192.168.0.10
10-12-03
GCD-CP10 Network Setup – Default
Gateway
Assign the default gateway IP address for the
GCD-CP10.
0.0.0.0 ~ 126.255.255.254
128.0.0.1 ~ 191.254.255.254
192.0.0.1 ~ 223.255.255.254
0.0.0.0
10-12-09
GCD-CP10 Network Setup – IP Address
Set IP address for GPZ-IPLE.
The IP Address assigned in Program 10-12-01
cannot start with the same leading digits as the IP
Address assigned here.
0.0.0.0 ~ 126.255.255.254
128.0.0.1 ~ 191.255.255.254
192.0.0.1 ~ 223.255.255.254
172.16.0.10
10-12-10
GCD-CP10 Network Setup – Subnet Mask
Set the Subnet mask of the GPZ-IPLE.
128.0.0.0 | 192.0.0.0 | 224.0.0.0
|240.0.0.0 | 248.0.0.0 | 252.0.0.0
|254.0.0.0 | 255.0.0.0
|255.128.0.0 | 255.192.0.0
|255.224.0.0 | 255.240.0.0
|255.248.0.0 | 255.252.0.0
|255.254.0.0 | 255.255.0.0
|255.255.128.0 | 255.255.192.0
|255.255.224.0 | 255.255.240.0
|255.255.248.0 | 255.255.252.0
|255.255.254.0 | 255.255.255.0
|255.255.255.128
|255.255.255.192
|255.255.255.224
|255.255.255.240
|255.255.255.248
|255.255.255.252
|255.255.255.254
|255.255.255.255
255.255.0.0
10-13-01
DHCP Server Mode
Enable/Disable the built-in DHCP Server.
Enable/Disable the built-in DHCP Server.
0 = Disable
1 = Enable
0
10-13-02
Lease Time
Lease time of the IP address to a client. Press
the Transfer Key to increment to the next
setting data.
Days 0 ~ 255
Hour 0 ~ 23
Minutes 0 ~ 59
0 day
0 hour
30 minutes
10-13-05
Last DHCP Data
If 10-13-01 is enabled, this setting determines if
DHCP resource is enabled or disabled.
0 = Disable
1 = Enable
1