NEC Univerge SV9100 - Page 765

765
Program
Number
Program Name/Description
Input Data
Default
10-29-05
SIP Server Information Setup – Registrar
Mode
This program is used to Enable/Disable the
ability to Register to the ITSP.
In Registration mode (IP or Domain Name)
this MUST be enabled.
0 = None
1 = Manual
(Profile 1 ~ Profile 2)
0
10-29-06
SIP Server Information Setup – Registrar IP
Address
Define the Registrar IP Address. The carrier
may provide an IP address. In most cases, a
domain name is used so this entry is left at the
default.
0.0.0.0 ~ 126.255.255.254
128.0.0.1 ~ 191.255.255.254
192.0.0.1 ~ 223.255.255.254
(Profile 1 ~ Profile 2)
0.0.0.0
10-29-07
SIP Server Information Setup – Registrar
Port Number
Define the Registrar Port Numbers.
0 ~ 65535
(Profile 1 ~ Profile 2)
5060
10-29-11
SIP Server Information Setup – Registrar
Domain Name
Define the Registrar Domain Name (normally
provided by the SIP carrier).
For example: mysipserver.sipprovider.com
Maximum of 128 characters.
(Profile 1 ~ Profile 2)
No Setting
10-29-12
SIP Server Information Setup – Domain
Name
Define the domain name of the SIP PROXY
Server provided by the SIP Carrier.
For example: if the SIP Proxy server address is
proxy.sipprovider.com, you would assign
sipprovider.com in this program.
If no SIP Proxy address is provided, use the SIP
Registration address as the proxy address.
Maximum of 64 characters.
(Profile 1 ~ Profile 2)
No Setting
10-29-13
SIP Server Information Setup – Proxy Host
Name
Assign the Proxy Host Name of the SIP PROXY
Server provided by the SIP Carrier.
For example: if the SIP Proxy server address is
proxy.sipprovider.com, you would assign proxy
in the program.
If no SIP Proxy address is provided, use the SIP
Registration address as the proxy address.
Maximum of 48 characters.
(Profile 1 ~ Profile 2)
No Setting
10-29-14
SIP Server Information Setup – SIP Carrier
Choice
Define the SIP Carrier Choice.
Selecting Carrier B automatically sets
Program 10-29-16 to on (1). Program 10-29-16
MUST be set to off for incoming calls to route using
the lowest available trunk port.
Each certified vendor my use a different carrier
type. Visit NTAC website (http://www.necntac.com)
to verify the proper setting per vendor.
0 ~ 26
1 ~ 26 =
Carrier Type A ~ Carrier Type Z
(Profile 1 ~ Profile 2)
0