766
SIP Server Information Setup – Registration
Expiry (Expire) Time
This program defines the SIP Trunk
Registration timer.
This timer is negotiated between the Carrier
and the SV9100 during the registration process.
The Carrier will make the final decision on the
value to be used which means the value
specified in this program may be ignored.
When half of this timer expires, the SV9100 will
re-register itself with the Carrier.
120 ~ 65535 seconds
(Profile 1 ~ Profile 2)
SIP Server Information Setup –
Authentication Trial
Define the number of times the SV9100 will
attempt to authenticate before timing out and
not completing the registration process.
Recommend changing this to at least 2 in case
the first attempt did not succeed due to network
problems or any other issues.
0 ~ 9
0 = No Authentication
(Profile 1 ~ Profile 2)
1
(1 Authentication
Attempt)
SIP Server Information Setup – NAT Router
If the SV9100 is connecting to the SIP Carrier
using NAT Translations, this setting must be
enabled.
0 = Disabled
1 = Enabled
(Profile 1 ~ Profile 2)
SIP Trunk Registration Information Setup –
Registration
Enable/Disable the SIP trunk registration.
0 = Disable
1 = Enable
(Profile 1 ~ Profile 2)
SIP Trunk Registration Information Setup –
User ID
Assign the SIP User ID provided by your SIP
Carrier. In most cases this is your 10 digit main
billing number. This field is also used to send
outbound caller ID information when not
programmed on a per station or per trunk basis.
For non-registration and SIP Tie Lines to
another system, you MUST have a USER ID
entered.
Maximum of 32 characters.
(Profile 1 ~ Profile 2)
SIP Trunk Registration Information Setup –
Authentication User ID
Define the Authentication USER ID for the SIP
Trunk.
Maximum of 64 characters.
(Profile 1 ~ Profile 2)
SIP Trunk Registration Information Setup –
Authentication Password
Define the Authentication Password for the SIP
Trunk.
Maximum of 32 characters.
(Profile 1 ~ Profile 2)
UPnP Setup – UPnP Mode
Enable/Disable UPnP.
To Next Page
Loading...
