NEC Univerge SV9100 - ISDN - PRI Installation

800
14-01-36
Basic Trunk Data Setup – Sending Caller
Name on Outgoing Calls (ISDN Trunk)
Disable/Enable sending the Caller Name on
outgoing ISDN trunks.
0 = Disable
1 = Enable
0
15-01-10
Basic Extension Data Setup – Sending
Caller Name on Outgoing Calls (ISDN Trunk)
Disable/Enable sending the Caller Name on
outgoing ISDN calls per station.
0 = Disable
1 = Enable
0
20-19-09
System Options for Caller ID – Calling Party
Name for ISDN Trunk
Enter the Calling Party Name to be used
system wide for outgoing ISDN calls.
If no data is entered, it will follow the station
name in Program 15-01-01.
Maximum of 12 characters.
No Setting
21-12-01
ISDN Calling Party Number Setup for Trunks
– Calling Party Number Data
Assign Calling Party Numbers for each trunk
(maximum 16 digits per entry).
After the above programming is complete a
reset of the GCD-2BRIA is required.
Maximum of 16 characters
(1 ~ 0, *, #)
No Setting
ISDN – PRI Installation:
Program
Number
Program Name/Description
Input Data
Default
10-03-04
ETU Setup (PRTA PKG Setup) – Layer 3
Timer Type
Set up and confirm the Basic Configuration
data for each CD-PRTA This program selects
the Layer 3 timer type (1 ~ 5). Each timer value
of Layer 3 is set up for each type in Program
81-06 (T-Bus).
1 ~ 5
1
10-03-06
ETU Setup (PRTA PKG Setup) – Length of
Cable
Set up and confirm the Basic Configuration
data for each GCD-PRTA. Select the length of
cable to be used.
0 = Level 1
1 = Level 2
2 = Level 3
3 = Level 4
4 = Level 5
2
10-03-08
ETU Setup (PRTA PKG Setup) – Dial
Sending Mode
ISDN protocol definition. Select either enblock
or overlap sending.
0 = Enblock Sending
1 = Overlap Sending
0