NEC Univerge SV9100 - Page 861

861
A Message Waiting key simplifies this feature operation.
Telephone-to-telephone Message Waiting works when the voice mail is installed.
The MW (Message Waiting) LED may be used to indicate voice mail messages if no
extension number is assigned to the voice mail key in system programming
If the following programs are changed while the phone is online, a reset of the feature is
required before the setting takes effect.
Program 15-02-35 Message Waiting Lamp Cycle for Calling Extension
Program 15-02-36 Message Waiting Lamp Cycle for Called Extension
Program 15-02-37 Voice Mail Message Wait Lamp Color
Program 15-02-38 Voice Mail Message Wait Lamp Cycle
 For example, if a message waiting was set before any of these programs were changed, the
lamp remains the same until the message waiting is set again.
If both Voice Mail Message and Message Wait indication are set, the color set for Message
Wait overrides the color used for Voice Mail Message indication.
When the system has the Hotel Motel license (0007), the Message Waiting Indication
(MWI) on a DSS Console for an extension is a Green LED. Without the Hotel Motel license
the MWI on a DSS Console for an extension is a Red LED.
Default Settings
Enabled
System Availability
Terminals
All Terminals
Required Component(s)
None
Related Features
Handsfree Answerback/Forced Intercom Ringing
Hotel/Motel
Programmable Function Keys
UM8000 Mail
InMail
Voice Response System (VRS)