NEC Univerge SV9100 - Page 943

943
Program
Number
Program Name/Description
Input Data
Default
20-03-01
System Options for Single Line Telephones
– SLT Call Waiting Answer Mode
For a busy single line (500/2500 type)
telephone, set the mode used to answer a
camped-on trunk call.
For ESL sets, enabling this option (1) allows the
user to dial Service Code for Voice Mail
Conversation Record.
0 = Hookflash (Hooking)
1 = Hookflash + Service Code
794
Service Code 654 is for Live
Recording at SLT (Program
11-12-53).
0
20-03-02
System Options for Single Line Telephones
– Ignore Received DP Dial on DTMF SLT
Port
Define whether the system should receive dial
pulse and DTMF signals (0) or ignore dial pulse
and only accept DTMF signals (1).
0 = Do Not Ignore (No)
1 = Ignore (Yes)
0
20-03-03
System Options for Single Line Telephones
– SLT DTMF Dial to Trunk Lines
Type 0: The system keeps the digits dialed
by the single line telephone on a trunk in a
buffer. After they are received, the system
sends all the digits to the trunk. If the time
space between digits is longer than the time
in Program 20-03-04, the system considers
all digits received.
Type 1: The system passes the received
digits from the single line telephone to the
trunk immediately. If the single line
telephone has a Last Number Dial key
without a pause, this key may not be able to
use the Last Number Dial key with the Type
1 setting.
When using a third-party external paging
device, set this option to 1. In addition, set
Program 20-03-04 to 1. These programs must
be set for Wireless DECT (SIP) users to break
dial tone on an analog trunk that is used for
paging.
0 = Receive all dialed data,
before sending (All)
1 = Direct through out (Direct)
0
20-03-04
System Options for Single Line Telephones
– Dial Sending Start Time for SLT or ARS
When ARS or an analog extension user
accesses a trunk and dials an outside call, the
system waits this interval before outdialing the
first digit.
0 ~ 64800 seconds
3
20-03-05
System Options for Single Line Telephones
– SLT Operation Mode
Set the operation mode for single line
telephones.
0 = Normal Mode
1 = Extended Mode1
2 = Extended Mode2
0
20-03-06
System Options for Single Line Telephones
– Headset Ringing Start Time (for SLT)
Define the headset ringing start time. After this
time expires after a single line telephone is
off-hook, the system sets the single line
telephone to headset ringing mode.
0 ~ 64800 seconds
5