NEC Univerge SV9100 - Connectors

Issue 1.2 UNIVERGE SV9100
4 - 56 Installing the SV9100 Blades
5.1.4 Connectors
Table 4-28 GCD-4COTA RJ-61 Cable Connector Pin-Outs on page
4-56 shows the pin-outs for the RJ-61 connector. Refer to Figure
4-14 GCD-4COTA Blade on page 4-53 for an illustration showing the
location of the connectors on the 4COIU blades.
Table 4-28 GCD-4COTA RJ-61 Cable Connector Pin-Outs
RJ-61 Cable Connector – CN2, Trunks
The CN2 connector is polarity sensitive (tip-to-tip, ring-to-ring).
Pin No. Connection
1 Circuit 4 – Tip
2 Circuit 3 – Tip
3 Circuit 2 – Tip
4 Circuit 1 – Ring
5 Circuit 1 – Tip
6 Circuit 2 – Ring
7 Circuit 3 – Ring
8 Circuit 4 – Ring
RJ-61 Cable Connector – CN3, SLT Interface for Power Failure
Pin No. Connection
1–
2–
3 Circuit 2 – Tip
4 Circuit 1 – Ring
5 Circuit 1 – Tip
6 Circuit 2 – Ring
7–
8–