NEC Univerge SV9100 - Installing Line Key Kit (12 LK-L KIT); Installing the 12 LK-L KIT

Issue 1.2 UNIVERGE SV9100
5 - 50 Installing DT Series Digital and IP Multiline Terminals
4.5 Installing Line Key Kit (12LK-L KIT)
The 12LK-L KIT Provides twelve additional buttons to ITL or DTL multiline
terminals. The 12LK-L KIT
kit:
 Mounts directly to top side of terminal
 Supports Red and Green LED colors
4.5.1 Installing the 12LK-L KIT
1. Turn multiline terminal upside down.
. Only one 12LK-L KIT can be attached to the DTL/ITL multiline
terminal.
2. Pry the right-side panel from the multiline terminal.
3. From the lower left or right corner, pry the Line Key Panel from
the multiline terminal (refer to Figure 5-41 Removing the Line
Key Panel on page 5-51).
Figure 5-40 12LK-L Kit
To prevent possible damage to the 12LK-L KIT or
the DTL/ITL multiline terminal during installation
or removal, disconnect the line cord/LAN cable
and the AC/DC adapter from the DTL/ITL
multiline terminal.