UNIVERGE SV9100 Issue 1.2
System Hardware Manual 5 - 59
4.7.1 Installing the Numbered Keypad on a Multiline Terminal
1. Remove the plastic panels. (Refer to paragraph Figure 5-51
Remove Plastic Panels.)
2. Pull down on the tab and lift the Numbered Keypad away from
the telephone to remove the existing button. See Figure 5-52
Removing Numbered Keypad from DT300/DT700 Series
Terminal.
Figure 5-51 Remove Plastic Panels
Figure 5-52 Removing Numbered Keypad from DT300/DT700
Series Terminal
To prevent possible damage to the Numbered
Keypad or the DTL/ITL multiline terminal during
installation or removal, disconnect the line cord/
LAN cable and the AC/DC adapter from the DTL/
ITL multiline terminal.
To Next Page
Loading...
