UNIVERGE SV9100 Issue 1.2
System Hardware Manual 5 - 77
3. Pry the side panel from the multiline terminal.
4. Return the multiline terminal to the buttons side up
position.
5. Fit the projections on the side of the 8LK-L UNIT
into the guide holes on the side of the multiline
terminal.
6. Secure the 8LK-L UNIT with the two screws
provided.
7. Turn the multiline terminal upside down.
Figure 5-73 Remove Side Panel from Multiline Terminal
Figure 5-74 Securing the 8LK-L UNIT with Screws
To Next Page
Loading...
