Issue 1.2 UNIVERGE SV9100
5 - 80 Installing DT Series Digital and IP Multiline Terminals
3. Remove the screw (refer to Figure 5-77 Remove
Side Panel from Multiline Terminal on page 5-79).
4. Carefully, return the multiline terminal to the buttons
side up position.
5. Remove the soft keys and line key kit from the
telephone.
6. Gently lift the small black bar on the ribbon cable
connector (refer to Figure 5-78 Ribbon Cable
Connector).
7. Plug ribbon cable on back of 8LKD (LD)-L UNIT into
connector until pressure is felt.
8. Press down on the black bar to lock the cable into
place (refer to Figure 5-79 Ribbon Cable Installed
on page 5-81).
Figure 5-78 Ribbon Cable Connector
To Next Page
Loading...
