UNIVERGE SV9100 Issue 1.2
System Hardware Manual 5 - 111
10. Insert the cradle connecting cable of the Bluetooth Cradle
(BTC) into the unit connector.
11. Fit the projections on the side of the Bluetooth Cradle into the
guide holes on the side of the terminal and pull toward you
(Figure 5-123 Attach Bluetooth Cradle to the Multiline
Terminal) until the unit snaps into place.
12. Attach the side panel to the Bluetooth Cradle.
13. Press the connecting cable into the grooved cutout.
Figure 5-123 Attach Bluetooth Cradle to the Multiline Terminal
Figure 5-124 Grooved Cutout for Connecting Cable
To Next Page
Loading...
