UNIVERGE SV9100 Issue 1.2
System Hardware Manual 6 - 3
1. Remove the screw from the front of the PGD(2)-U10 ADP.
2. Using a screwdriver, break out the plastic piece covering the cable hole.
3. Set the S3 – S6 jumpers to the proper settings for the function to be used
(refer to Table 6-2 PGD(2)-U10 ADP S3 – S6 Jumper Settings on page
6-4).
Figure 6-2 Remove Cover from PGD(2)-U10 ADP
Figure 6-3 Remove Plastic Cover from Cable Hole
To Next Page
Loading...
