UNIVERGE SV9100 Issue 1.2
System Hardware Manual 6 - 45
4. Push the two stopper tabs through the slots to separate the tilt
leg from the leg support.
5. Lay the tilt leg and the leg support flat.
6. Press the two tabs locking the legs to the multiline terminal and
pull the legs toward you, lifting to remove.
7. Disconnect serial connection cord from terminal body. Leave
cord connected to the cradle unit.
Figure 6-36 Separate Tilt Leg from Leg Support
Figure 6-37 Remove Legs From Multiline Terminal
To Next Page
Loading...
