NEC Univerge SV9100 - Page 54

Issue 1.0
UNIVERGE SV9100
42
System Maintenance Manual
Enter
Function
DIM Output
IP GW
Displays the SV9100 Default
Gateway (PRG10-12-03)
[ Default Gateway ] : 192.168.1.254
IP ARP
Displays the SV9100 ARP
(Address Resolution Protocol)
cache. This is a table of MAC
address to IP Address
mappings.
See below
IP ROUTE
Displays the SV9100 routing
table. Usually this will consist
of just a few entries, as the
default gateway is used for
any traffic destined for a
different IP subnet.
See below
IP DSP INFO
This shows how many DSP
channels are in use at a
particular moment in time.
See below.
IP DSP INFO 1
This shows how many DSP
channels are in use at a
particular moment in time for
all device types.
See below.
Ping <ip address>
The commonly used “ping”
utility has been implemented
on the GCD-CP10. This is a
very useful fault finding tool.
VoIPU >ping 192.168.11.200
Pinging 192.168.11.200 with 32 bytes of
data:
Reply from 192.168.11.200:
Reply from 192.168.11.200:
Reply from 192.168.11.200:
Reply from 192.168.11.200: Ping statics
for 192.168.11.200:
Packets: Sent = 4, Received = 4, Lost = 0
(0% loss):