3
.. AIR CONTROLS
The Nectre Mk3 has two air controls for controlling the fire.
Top air slide: This allows air to enter the firebox from above
the door where it is then drawn down into the base of the
fire while keeping the glass clean.
Bottom air slide: This allows air to enter directly into the
base of the fire and is used as a boost especially when
getting the fire up to temperature.
Secondary air holes in the rear of the firebox provide
additional oxygen for a more complete combustion of the
gases released from the burning wood.
.. DOOR HANDLE
Warning: door handle may get hot if appliance has been left
in High burn setting for an extended period of time, in which
case use a protective glove or equivalent to open.
Open the top air slide before opening the door to eliminate
the chance of backdraft and/or smoke entering the room.
.. WOOD STORAGE COMPARTMENT
Warning: the Nectre Mk3 features a storage area
for a small amount of firewood. Do not overload this
compartment - ensure that there is at least a 40mm gap to
the ceiling of the unit, and no combustible fuel forward of
the storage area.
.. FAN
The fan can be used to spread heat around the room
quicker, as well as distribute heat into other rooms. It does
not have to be on if not required. Plug the lead from the unit
into a power-point.
A remote control supplied with the heater is used to turn
the fan on, determine the fan speed, and to set a timer.
The fan speed of the heater can be controlled with the
Low/Med/Hi buttons.
OFF LOW
MED
1H
8H
2H
4H
HI
A timer function allows the fan to be
switched off after a set period of time
- 1/2/4/8 hours.
Select the desired time period with
the lower buttons on the remote. The
heater will beep in response to the
amount of time selected - 1 beep for 1
hour, 2 beeps for 2 hours, etc.
To cancel the timer, press the central
“Cancel Timer” button. The heater will
emit a long beep.
To switch the fan off, press the Off
button.
. USING APPLIANCE FOR THE FIRST
TIME
The power cable for the Nectre Mk3 may be bundled in
the rear of the unit for transportation. Ensure that the
cable is pulled clear from the heater before lighting.
The first few times the appliance is lit, it will give off some
odorous fumes. This is caused by the paint curing.
Do not touch the paint work while it is curing otherwise it
can leave a permanent mark on the appliance.
Once the paint has cured it will not re-occur.
Keep the room well ventilated until fumes have cleared.
To Next Page
Loading...
