Nedap Luxon Bridge - User Manual

www.nedap-luxon.com
EN–US
Language
Luxon Bridge
p/n 9986294
Installation guide
1. Before you start,
check the package contents
 Luxon Bridge
 DIN-rail clips (2x)
 Blind plug for cable gland (2x)
 Installation guide
Installation of electrical components must
be completed by a certified electrician as per
local codes and regulations.
2. Mounting
1. Mount the Luxon Bridge to a wall or other flat mounting surface
using pan-head screws, max 4.5mm diameter.
2. Alternatively, in case of DIN-rail mounting, click the DIN-rail clips
into the rear of the Luxon Bridge.
3. Wiring
Connect the Luxon Bridge to mains power.
(100-347Vac 50/60Hz)
Make sure the mains power source is not powered
during installation.
Connect the required sensor or switch to an I/O port.

Nedap Luxon Bridge Specifications