Nedap uPASS TARGET - Nedap Antenna Interface

uPASS Target | installation guide
21/
42
3.2.5 Nedap antenna interface
The Nedap antenna interface is used to connect the uPASS Target to Nedap AEOS access control hardware such as the
AP1001. The uPASS reader simulates a 120 kHz Nedap proximity card to the AP1001. This only works with Nedap-XS
and EM4102 formatted UHF tags.
The uPASS Target can replace the 120 kHz antenna. The “HF Data” must be connected to the “ANT” connection and
the “Ground” to “GND” (see Figure 16).
Figure 16: Replacement of 120 kHz antenna
Another possibility is to leave the 120 kHz in place and connect the uPASS Target. That way 120 kHz and uPASS Target
both can be used (see Figure 17).
Figure 17: Addition to 120 kHz antenna
The Nedap antenna interface is located at CONN. 3.
Figure
18: CONN. 3
Pin
Function
1
-
2
HF Data
3
-
4
-
5
Ground
Table 4: Nedap antenna connection
HF Data
Ground
ANT
GND