Nedap VP1006 - Appendix D: LED indicator overview

VP1006-200PM-00 OEM ISO Reader Manual version 2.6 / Page 17
Appendix D: LED indicator overview
POWER
Green on
Power on
off
No power
STATUS
Blue
Slow blinking
Fast blinking
1 short flash
2 short flashes
3 short flashes
Operating ok
Downloading or error during download
V-pack not coupled
Firmware present but not active
No firmware present
Display
on
Address indicated
No communication
off
Communication status ok
V in
Green on
Input power applied
off
No power
Orange
Low power, less than 20V
Orange blinking
Wrong CAN-bus connection, Vin and Vout swapped
Red
Error, plus and minus swapped
V out
Green on
Output power
off
No power
Orange blinking
Low power
Red blinking
Error, plus and minus swapped
COM
Green on
V-pack is last one on the bus
off
V-pack is not last one on the bus
Orange blinking
CAN-bus error and last V-pack on the bus
Red
CAN-bus error
Red blinking
CAN-bus warning / connected wrong
+24V
Green on
24V output switched on
off
Output switched off
M1 .. M4
Green on
Output on
off
Output off
Red blinking
Output error
I1 .. I4
Green on
Input contact open
off
Input contact closed
TUNING /ID
Green on
Green blinking
Antenna ok
Antenna ok and tag identified
Red on
Antenna not tuned correctly
Red on
Antenna not tuned correctly
Red blinking
Antenna error / not connected