nedis BTTC100BK - Page 7

7
Receiver mode (image B)
1. Set the mode switch A
1
to RX.
2. Plug the 3.5 mm to 3.5 mm audio cable A
8
into the aux output/
input A
5
.
3. Plug the other end of A
8
into the audio device.
4
You can also connect an audio device with the 3.5 mm female to
2 x RCA cable A
7
.
4. Switch on the product.
A
2 ashes quickly.
5. Enable Bluetooth on the device you want to pair.
6. Select "BTTC100BK" from the list of available Bluetooth devices
on your device.
A
2 ashes slowly to indicate pairing is successful.
7. Press A
4
to play or pause music.
Transmitter mode (image C)
1. Set A
1
to TX.
2. Plug A
8
into A
5
.
3. Plug the other end of A
8
into your audio source.
4
You can also connect an audio device with the 3.5 mm female to
2 x RCA cable A
7
.
4. Switch on the product.
A
2 ashes quickly.
5. Keep your Bluetooth audio device within range and switched on.
4
Pairing time will vary depending on the device used.
A
5 ashes slowly to indicate pairing is successful.
Declaration of Conformity
We, Nedis B.V. declare as manufacturer that the product BTTC100BK
from our brand Nedis
®
, produced in China, has been tested according
to all relevant CE standards and regulations and that all tests have
been passed successfully. This includes, but is not limited to the RED
2014/53/EU regulation.
The complete Declaration of Conformity (and the safety datasheet if
applicable) can be found and downloaded via:
webshop.nedis.com/BTTC100BK#support
For additional information regarding the compliance, contact the
customer service:
Web: www.nedis.com
E-mail: service@nedis.com
Nedis B.V., de Tweeling 28
5215 MC ’s-Hertogenbosch, the Netherlands