ENGLISH
Part III
Use the Transmitter:
For each weather station there is a transmitter. Set the channel after inserting
the battery at the rear of the transmitter. There are 3 settings: channel 1, 2 and 3.
The maximum distance between the station and the transmitter is 20 m in
open areas. Greater distance or buildings in-between station and transmitter
will aect signal transmission and reception.
Transmitter shall be kept away from rain or water.
Part IV
Points to note:
Tolerance:
• The tolerance for temperature variation is +/– 2 °C.
• The tolerance for humidity variation is +/– 5%.
Remarks:
1. 3x AAA batteries or DC 4.5 V adapter are needed to operate the weather
station.
2. 2x AAA batteries are needed to operate the transmitter.
3. The transmitter distance is 30 m.
4. Transmits one time every second. The light will ash at the same time.
5. Select the channel and change the temperature unit inside the battery
compartment.
6. When the RCC signals ashing, the handset function is turn o. Press the
DOWN once to stop the RCC signal ashing; it will recover the handset
function.
7. The system’s channel is CHANNEL1.
To Next Page
