NEO Coolcam Motion Sensor 2 User Manual

Parameter 11: Led Blink Enable
This parameter defines the Led on/off enable. If this parameter is set to ‘1’, led blink will be
enabled, the led will blink once when motion sensor detect a movement. Otherwise, the led
will be turned off always.
Size: 1 Byte, Default Value: 1
Setting
Description
0
Disable
1
Enable
Parameter 12: Motion Event Report One Time Enable
Size: 1 Byte, Default Value: 1
Setting
Description
0
The motion detected event will be sent to controller when device detects
a movement event
1
he motion detected event will be sent to controller only once until device
report motion cleared event.
Parameter 99: Ambient light intensity calibration
This parameter defines the calibrated scale for ambient light intensity. Because the method
and position that the sensor is mounted , and the cover of sensor will bring
measurement error,user can get more real light intensity by this parameter setting. User
should run the steps as blows for calibrating.
Size: 2 Byte, Default Value: 10
Setting
Description
1 - 65536
Ambient light intensity calibration

NEO Coolcam Motion Sensor 2 Specifications

General

Brand	NEO Coolcam
Model	Motion Sensor 2
Category	Accessories
Language	English