Installation of the protection in the harness
The protection NEO-Koroyd is integrated in the Suspender. The harness is delivered
with the protection installed in a pocket, which is accessed by 2 zips on the side of
the geometry. In case of heavy impact, you should replace the protection. Follow the
steps below to install the new protection.
Remove a carabiner and open the zips that hold the rescue container on each side,
to facilitate the opening of the protection pocket aperture.
Slide the protection from above and check the emergency webbing remains in the
correct position between the back of the harness and the back protection.
Replace the protection and close the zips of the rescue container. To reinstall the
carabiner please refer to the section « carabiners installation ».
38
EN
To Next Page
Loading...
