Need help?Do you have a question about the Neptune Technology T-10 and is the answer not in the manual?
General| Model | T-10 |
|---|---|
| Category | Measuring Instruments |
| Type | Water Meter |
| Minimum Test Flow Rate | 0.25 gpm |
| Pressure Rating | 150 psi |
| Flow Range | 0.25 to 20 gpm |
| Connection Size | 1 inch |
| Size | 5/8", 3/4", 1", 1 1/2", 2" |
| Material | Bronze |
| Register Type | Direct Read |
| Connection Type | NPT |
| Accuracy | +/- 1.5% over the normal operating range |
| Lay Length | 7 1/2 inches |
Lists the essential parts required for the meter's chamber assembly, including upper and lower halves, ball and disc, diaphragm, and gasket.
Guides the user to correctly insert the thrust roller into the ball and disc mechanism as a crucial step in chamber assembly.
Details the procedure for placing the ball and disc assembly into the lower section of the meter's chamber.
Instructs on how to properly insert the diaphragm into the lower half of the meter chamber during the assembly process.
Explains the method for snapping the upper and lower halves of the meter's chamber together to complete the casing.
Covers the step of inserting the outlet gasket into the assembled meter chamber, ensuring a proper seal.
Guides the placement of the completed chamber assembly into the meter's main casing, noting gasket orientation.
Details the process of inserting the strainer into the meter maincase and ensuring it is fully seated and flush.
Instructs on placing the liner/gasket into the meter maincase, ensuring the dome faces away from the meter.
Explains how to secure the bottom cap onto the meter maincase, completing the main body assembly.
Covers the initial step of inserting and hand-tightening the bolts that secure the meter components together.
Details the final step of using a 1/2 inch wrench to securely tighten all assembly bolts on the meter.
Guides the user to flip the meter and securely attach the register onto the bayonet by turning it clockwise.
To Next Page