2
English
Parts
How to assemble your electric skillet
Remove all parts from the packaging.
1. Locate and remove Lid Knob in packaging.
2. Place the screw through center hole of lid. The head of screw to inside of lid.
3. Place Protector Ring over screw threads on the outside of lid. Rough side of ring
facing glass.
4. Turn Lid Knob onto screw thread while pressing on head of screw.
5. Tighten screw unl snug. Do not overghten. The Lid is now ready for use.
Before rst use
Before using the appliance, READ AND SAVE ALL INSTRUCTIONS. Wipe down the
appliance with a so damp cloth and make sure there is no metal or foreign objects
on the temperature control. Wipe dry with so cloth.
Operaon
1. Place appliance on a at, heat resistant, stable surface in a well venlated area.
2. Make sure the temperature controller is in OFF posion. Insert control into inlet
on the side of skillet. Then insert plug into electrical outlet.
3. Adjust controller to desired seng. NOTE: The signal light on controller
indicates heat seng. When desired seng is reached, the light will turn o.
It will connue to cycle on and o during use to indicate heat seng is being
automacally maintained.
4. Preheat the skillet with the lid on for 10 minutes or unl the indicator light goes out.
NOTE: The cooking temperatures listed in this user manual are esmates. Adjust the
cooking temperature slightly up or down to achieve the results you prefer.
5. A steam vent is located on the Glass Lid. The steam vent allows steam to escape
while cooking with the lid in place. CAUTION: Escaping steam is hot! Be careful
when removing or liing lid. Oven mis are recommended when removing cover
from skillet base or when replacing it.
Handles Lid Knob
Temperature
Controller
Cooking Plate
Glass Lid