Nespresso VERTUO POP+ - Troubleshooting

EN
.
31
Light blinks while
machine is running.
• If the coee is flowing normally, this
indicates the machine is working properly.
• If only water is flowing, the machine is
executing a user request for either cleaning,
descaling or emptying the system. Refer
to the corresponding section in this user
manual.
• Turn the machine to “OFF mode” by
pushing the buon for 3 seconds and then
push it again to turn the machine ON. Now
wait approximately 20 minutes to allow the
machine to cool down aer extensive use.
Light blinks and
machine is not running.
• It will take some time before the coee flow
comes out (due to code reading and pre-
weing the coee).
• Check that a fresh capsule is inserted in the
correct position, that the lever is properly
locked and push the buon to start.
• Fill the water tank and push the buon to
start.
• Turn the machine to “OFF mode” by
pushing the buon for 3 seconds and then
push it again to turn the machine ON. Now,
wait approximately 20 minutes to allow the
machine to cool down aer extensive use.
Light blinks alternately
2 blinks and 1 pause
continuously. Machine is
not running.
• During regular Coee preparation:
1) Unlock the lever and open the machine
head to check that a fresh undamaged
capsule is inserted in the correct position.
2) Check that the lever is in “LOCKED”
position.
3) Check that the water tank is filled.
• During Descaling, Emptying and Cleaning:
1) Check that the capsule is ejected.
2) Check that the lever is in “LOCKED”
position.
• During Programming Volume:
1) Check if a capsule has been well inserted.
2) Please refer to the corresponding
chapter.
TROUBLESHOOTING  PAGE 2/3